Amazon and have just tried it out now for this year’s Christmas cards – it won’t cut completely through thin card on either the Cuttlebug or the Wizard. I have used various plates, pads, extra card as shim with no success. Any ideas? Home
2010-10-14
Quic-Won’t-Kutz
Help! I bought this 4”x4” Special Edition Revolution die last October from an American company through Amazon and have just tried it out now for this year’s Christmas cards – it won’t cut completely through thin card on either the Cuttlebug or the Wizard. I have used various plates, pads, extra card as shim with no success. Any ideas?
Amazon and have just tried it out now for this year’s Christmas cards – it won’t cut completely through thin card on either the Cuttlebug or the Wizard. I have used various plates, pads, extra card as shim with no success. Any ideas?
Subscribe to:
Post Comments (Atom)
2 comments:
The sandwich I have written down for the Cuttlebug and a Quickutz die is:
Plate A
Plate B
Card stock
Quickutz die
Plate C
Not sure if that will help. When I am not getting a deep enough cut I add layers of card stock for shims until it cuts well or, if it is very loose, a piece of chipboard.
I hope you can figure it out. :)
That was helpful, thanks, Rita.
Post a Comment